 |
| Old frame |
Quick post on how I re-did an old window frame that my sister gave me. Actually she gave me about 5 of them but told me if I do re-do them, she wanted this one back. And what better occasion to re-do it for than her birthday?Here we go: I started by sanding & removing the old paint. I like to use an orbital hand sander with 60, 80, 100 & 120 grit sand paper, moving progressively up until I got the desired texture of the wood I wanted. An electric hand sander also helped for the flat, square areas where the round orbital doesn't fit. I also removed old caulking and removed the pane of glass, setting it aside to clean up later. I also use the air compressor to blow off the excess dust as I sand.
 |
| Frame sanded & dust aired off |
 |
| Glass cleaned & scraped off with a razor blade |
 |
| Primed & painted |
I then used Gorilla Wood Glue to tighten up the frame & bring it back to square. This glue is sand-able & paint-able which is what I did after the glue had dried. I used a gray spray primer all over in 2 coats. After the first coat was dry I wasn't happy with the texture of the wood in some spots so I went back over those spots lightly with a 220 grit disk. After removing the excess dust, I hit it again with another coat of primer. After the primer was dry, I went over it with Krylon's Almond color in a satin finish. This also was sprayed in 2 coats, front & back side of the frame.
 |
| Word placement on glass |
 |
| Saw tooth hangers |
While the paint was drying, I used my Cricut to cut out the words COUNTRY STRONG on contact paper. I made 2 straight lines with an expo marker and stuck the letters down after peeling the backing off onto those lines. Then I wiped off any extra marker as well as finger prints before using Krylon's Frosted Glass finish spray paint on it. The side with the letters got 2 coats and the back side only got 1 coat. After the frame was dry & the glass was dry, I added 2 saw tooth hangers on the back so my sister can hang it on her living room wall.
 |
| Caulking around the inside edge |
I put the pane of glass back into the frame & used some Power Grab adhesive to glue it down to the inside of the frame and then took a semi-translucent caulking around the edges to seal it into the frame. After the silicon was dry I added the ruffled ribbon all the way around and the decorative edging on the bottom section of the ribbon. The flower grouping was glued together prior to being glued to the frame. A cross on the other corner & a rosette finished it off. All of the decorative items were stuck down with Power Grab adhesive, which is my go-to adhesive for crafting. Much easier than heating up the hot glue gun, washes up easier than super glue and more durable than Elmer's glue or Eileen's Tacky glue.
 |
| Quick trip to Hobby Lobby for these do-dads |
 |
| All done! |
And all done & ready for her to decorate her living room with!!
No comments:
Post a Comment